Electronics Forum | Fri Apr 05 01:34:09 EDT 2024 | ddfreeze
the F1 bios menu thing did not work no matter what options I chose. The fix is to do the mod to the CMOS chip, or gamble on a substitute replacement.
Electronics Forum | Fri Apr 05 04:41:41 EDT 2024 | hta1979
I'm glad it was successful. According to them, the cmos setting was preserved. If the battery is completely discharged, it must be restored to the original state. The setup menu should work, but then there was no need for it.
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Sun Apr 07 20:35:00 EDT 2024 | jayx
I'd say it's much easier to do the external batter mod than replace the whole Dallas module. I've done it, works fine. There is a chip in the socket next to the module, best to remove it and put back when you finish with the mod.
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Mon Oct 08 13:31:50 EDT 2012 | highmillr
Yeah thanks swag, I do that ridiculous routine about every morning....im over it.... so I ordered a new belt..4 weeks lead time by the way from speedline. AND,...I took the tiny belt tensioners on each side and tightened both pretty tight and
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
